ASCII Adjust AX After Multiply


Hex Mnemonic Encoding Long Mode Legacy Mode Description
D4 ib (No mnemonic) A Invalid Valid Adjust AX after multiply to number base imm8.
D4 0A AAM A Invalid Valid ASCII adjust AX after multiply.

Instruction Operand Encoding

Op/En Operand 0 Operand 1 Operand 2 Operand 3


Adjusts the result of the multiplication of two unpacked BCD values to create a pair of unpacked (base 10) BCD values. The AX register is the implied source and destination operand for this instruction. The AAM instruction is only useful when it follows an MUL instruction that multiplies (binary multiplication) two unpacked BCD values and stores a word result in the AX register. The AAM instruction then adjusts the contents of the AX register to contain the correct 2-digit unpacked (base 10) BCD result.

The generalized version of this instruction allows adjustment of the contents of the AX to create two unpacked digits of any number base (see the "Operation" section below). Here, the imm8 byte is set to the selected number base (for example, 08H for octal, 0AH for decimal, or 0CH for base 12 numbers). The AAM mnemonic is interpreted by all assemblers to mean adjust to ASCII (base 10) values. To adjust to values in another number base, the instruction must be hand coded in machine code (D4 imm8).

This instruction executes as described in compatibility mode and legacy mode. It is not valid in 64-bit mode.

Pseudo Code

IF 64-Bit Mode
	tempAL = AL;
	AH = tempAL / imm8; (* imm8 is set to 0AH for the AAM mnemonic *)
	AL = tempAL MOD imm8;
The immediate value (imm8) is taken from the second byte of the instruction.

Flags Affected

The SF, ZF, and PF flags are set according to the resulting binary value in the AL register. The OF, AF, and CF flags are undefined.


64-Bit Mode Exceptions

Exception Description
#UD If in 64-bit mode.

Compatibility Mode Exceptions

Same exceptions as protected mode.

Virtual-8086 Mode Exceptions

Same exceptions as protected mode.

Real-Address Mode Exceptions

Same exceptions as protected mode.

Protected Mode Exceptions

Exception Description
#UD If the LOCK prefix is used.
#DE If an immediate value of 0 is used.